Dreame Z30 Manual De Usuario página 18

Care & Maintenance
EN
Tips:
• Always use genuine parts to keep your
warranty from being void.
• If the filter or nozzle becomes clogged,
the vacuum will stop working shortly
after being turned on. Clear the tube to
restore functionality.
• Before cleaning the dust cup, please
confirm that the plug is disconnected
and keep the vacuum's power button in
the off position.
• If the vacuum is not used for an
extended period, fully charge it, unplug
the power cord, remove the battery,
and store it in a cool, low-humidity
environment away from direct sunlight.
To avoid over-discharging the battery,
recharge the battery at least once every
three months.
Cleaning the Vacuum
Wipe the vacuum with a soft dry cloth.
Cleaning the Dust Cup, Pre-
Filter, and Cyclone Assembly
1. Press the dust cup bottom cover release
button, then empty the contents.
Fig. F-1
2. Press the dust cup release button and
remove it from the vacuum.
Fig. F-2
3. Remove the pre-filter first, and then
rotate the cyclone system to lift it out.
Fig. F-3
4. Rinse the cyclone assembly, pre-filter,
and dust cup until they are clean. After
washing, air dry for at least 24 hours.
Fig. F-4
Note:
• Please clean the dust cup as needed.
• It is recommended to clean the cyclone
6
system and pre-filter at least once every
3 to 4 months.
Cleaning the Filter
1. Remove the dust cup as shown in the
figure.
Fig. F-5
2. Remove the filter from the vacuum by
pulling it down in the direction shown in
the figure.
Fig. F-6
3. Rinse the filter with rotating it 360° .
Lightly tap the filter several times to
remove any debris caught in it.
Fig. F-7
4. Allow the filter to air dry for 24 hours.
Fig. F-8
Note:
• Only use clean water to wash the filter.
• Do not use detergent.
• Do not attempt to clean the filter with a
brush or finger.
• It is recommended to clean the filter once
every 4 to 6 months.
Cleaning the Multi-Surface
Brush
1. Turn the lock counterclockwise until it
stops, then remove the roller from the
roller brush.
Fig. F-9
2. Use scissors to cut off the hairs and
fibers that get stuck on the brush roller.
Wipe the dust from the notch and
transparent cover with a dry cloth or paper
towel. Thoroughly dry before use.
Fig. F-10
3. When it is dirty, rinse the brush roller
with clean water until it is clean.
Fig. F-11
4. Stand the brush roller upright for at
least 24 hours until it is fully dry.
Fig. F-12