Gima SP-10 Guía De Uso página 14

a. Main parameter interface: display the ratio of predicted value and measured value of three main parameters.
Ratio reflects health status, correct settings of personal information is the key to obtain accuracy ratio. Besides,
this interface can also display battery status, time, case number and health status indicator, as shown in Fig.4.
b. Health status indicator: indicate the ratio of measured value and the predicted value, display the testee health
condition in image. I.e. Compare the measured value with the reference value in same situation. When the value
is lower than 50%, only red indicator is displayed, which means testee should pay attention and go to hospital
in time. When the value is in range from 50%-80%, red and yellow indicator are displayed, which means it
should be noticed. When the value is higher than 80%, all red, yellow and green indicator are displayed, which
means healthy. The determinate item of health status indicator is optional, it can be set in "Denote value" under
"Date management".
c. Other parameter interface: display four parameters except the main parameter, as shown in Fig.5.
d. Under [Main parameter] interface, press "Up" or "Down" key will enter [Other parameter] [Flow rate-volume
chart] [Volume-time chart] in turn, as shown in Fig.5, 6, 7. The four interfaces above are [Main interface].
Figure 5 Other parameter interface Figure 6 Flow rate-volume chart Figure 7 Volume-time chart
14