Husqvarna Aspire S20-P4A Manual De Usuario página 17

WARNING:
safety chapter before you assemble the
product.
Introduction
WARNING:
safety chapter before you assemble the
product.
To attach the shrub shear to the
telescopic shaft
1. Attach the shrub shear (A) to the telescopic shaft
(B). The shrub shear must move into the holder on
the telescopic shaft easily, if not, it is not installed
correctly. (Fig. 44)
2. Tighten the locking knob (C).
Note:
When the shrub shear is attached to the
telescopic shaft, the user interface of the shrub
shear is disconnected.
To install and remove the cutter blades
1. Align the cutter blade with the slot in the blade holder
on the product.
2. Push the cutter blade fully into the blade holder.
The cutter blade locks into position when you hear
a click.
3. Push the blade release buttons (A) on the blade
holder to remove the blades. (Fig. 45) (Fig. 46)
To install and remove the wheels (only
for grass blade)
1. Push the wheels (A) fully onto the product. (Fig. 47)
2. Push the release button (B) to remove the wheels.
(Fig. 48)
To install and remove the hedge
sweeper (only for bush blade)
1. Align the slots on the hedge sweeper groove (A) with
the slots on the bush blade (B). (Fig. 49)
To do a function check before you use
the product
1. Examine the air intake for dirt and damage. Remove
dirt and unwanted material from the product with a
brush.
2200 - 004 - 03.11.2023
Assembly
Read and understand the
Read and understand the
Operation
2. To lock the hedge sweeper to the bush blade, push
the hedge sweeper down (C) and in the direction of
the product (D). (Fig. 50)
3. Remove the hedge sweeper in the opposite
sequence.
To adjust the length of the telescopic
shaft
1. Lift the lever (A) on the shaft. (Fig. 51)
2. Adjust the telescopic shaft to an applicable length.
3. Push the lever down to lock the telescopic shaft.
To install the hook on the wall
• Install the hook indoors.
• Keep the hook out of sunlight and in ambient
temperature of -10°C to 70°C.
• Install the hook on a drywall, wood or concrete wall.
CAUTION:
can hold loads of minimum 30 kg.
• Install the hook on the wall with the 3 screws (A).
Use wall plugs (B) if it is necessary.
CAUTION:
screws are applicable for your wall type.
a) For Aspire S20-P4A: (Fig. 52)
b) For power unit: (Fig. 53)
• Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
To hang the product on the hook
• Hang the shrub shear on the hook as shown in the
illustration: (Fig. 54) (Fig. 55)
• Hang the power unit on the hook as shown in the
illustration: (Fig. 56)
2. Tighten all nuts and screws.
3. Make sure that the shrub shear is attached correctly.
4. Make sure that the lock button for power trigger
lockout is engaged.
Make sure that the wall
Make sure that the
17