Black and Decker CM2040 Manual De Instrucciones página 8

B
C
TO REMOVE BATTERY PACK:
• Open the battery port cover (15) as
described above.
• Depress the battery release button (17) on the
battery pack and pull battery pack out of tool as
shown in Figure D.
D
BATTERY STORAGE
An extra battery can be stored using the battery
storage compartment (11).
• Lift the storage compartment cover and slide
the battery into the compartment as shown in
Figure E. Battery in this compartment will not
actuate the mower.
15
14
16
17
8
E
This product can accept any of the batteries and
chargers listed in the chart below.
LI-ION Battery Packs and Chargers
Description Cat. #
Batteries: LI-ION LBX36, LBX1540, LBX2040, LBX2540, LBXR36
Chargers: LI-ION LBXR2036, LCS36, LCS40, LCS436
ASSEMBLY
WARNING:
Before assembly, make sure the
bail handle is released and the safety key is removed..
ATTACHING LOWER HANDLE
• Lift lower handle (4) into place making sure the
arrow (18) on the base of the mower lines up with
1, 2, or 3 on the base of the handle (19) (inset of
Figure F)
CAUTION:
Ensure each side of the lower handle is
set on the same number. The arrow must be lined up
with 1, 2, or 3 for operation.
• Close the handle height adjust levers (7) as shown
in Figure F. As you close each, make sure the
teeth are engaged as shown in Figure G.
• If the connection between the handle and lever
is too tight or loose, open the lever and adjust
the depth of the lever by turning the lever. Close
it again until the teeth are fully clasped and each
lever stays securely closed.