Replacing The Clipper Blades; Storage - Heart to Tail HC007B Manual Del Usuario

Replacing the clipper blades

WARNING!
Risk of electric shock!
Improper handling of the clipper may result in injury.
− Unplug the power cord of the clipper before replacing the
blades.
If the clipper stops cutting, the clipper blades may be blunt and need replacing.
Contact the after sales support via the contact information indicated on the
warranty card to order replacement blades.
1. Remove the two screws
with a crosshead screwdriver (see step 1 in Fig. G).
2. Carefully remove the worn out blades.
3. To install the replacement blades, put the new top blade
cutting blade) into position on the clipper head
4. Line up the new bottom blade
over the screw holes
5. Insert the screws, but before tightening them, make sure the blades are
properly aligned.
To align the blades, match the top and bottom blades, teeth up, point to
point. When the taper lever
should be approximately 0.03 inch (0.8 mm) back from and parallel to the
front edge of the bottom blade (see step 3 in Fig. G).
6. Tighten the screws after the top and bottom blades are aligned.

Storage

All parts must be completely dry before storing.
− Always store the pet grooming kit in a dry and dust-free place, preferably in
the storage case
− Attach the blade cover
not in use.
− Keep the pet grooming kit out of direct sunlight.
− Store the pet grooming kit safely out of the reach of children.
21
located at the bottom of the clipper blades
1
23
on the clipper head.
7
is pushed up, the end of the top blade teeth
20
.
8
over the clipper blades
22
(the larger blade) with its screw holes
2
(the smaller,
(see step 2 in Fig. G).
3
when the clipper is
Storage
3
21