Publicidad
Idiomas disponibles
Idiomas disponibles
EN
20
Setting Alarm
This unit can be used as an alarm clock, USB is activated to play at a preset
time.
1
Press the STANDBY switch to switch the unit to standby mode.
2
Make sure that you have set the clock correctly.
3
Press the ALARM button in shutdown state, the display will flash ON to
select setting alarm and the display will blink.
4
Press the ALARM confirm, the time display will blink.
5
Press FORWARD/BACK button repeatedly to set hour. Press ALARM to
confirm.
6
Press FORWARD/BACK to set minute.
7
Press ALARM to confirm, and then press FORWARD/BACK to select
USB status. Press ALARM to confirm.
8
The volume would turn up from 0 to 20 gradually.
9
Press ALARM button in shutdown state, the display will flash ON to
select setting alarm, and the display will blink.
10 Press the FORWARD/BACK button and select OFF to cancel alarm.
Setting Sleeptimer
Press and hold the SLEEP button, the display will blink. Press the button
repeatedly until the display shows the minute you want to set. You can set
10 to 90 minutes. It blinks three times to confirm, and then return to the
interface before. If you want to cancel the sleep mode, press to OFF, after
blanking three times, the sleep mode will cancel.
Publicidad
