Hart HFRL01 Manual Del Operador página 10

OPERATION
USING MANDRELS
See Figure 4, page 15.
The most common types of mandrel to use with this tool
include the standard mandrel which is used with grinding
wheels and emery wheels. Screw mandrels are used with
polishing wheels and polishing drums. Drum mandrels are
used with sanding drums.
To install:
 Verify the rotary tool switch is in the OFF (O) position.
 Install the mandrel.
If using the standard mandrel:
 Depress and hold the spindle lock button and rotate the
mandrel by hand until the spindle lock engages preventing
further rotation.
 Insert the slot end of the provided wrench into the slot on
top of the mandrel and unscrew.
 Remove mandrel screw and washer.
 Place desired accessory over mandrel shaft and align
accessory hole with mandrel hole.
 Insert mandrel screw with washer through the accessory
and mandrel shaft holes.
NOTE: The mandrel washer should be placed between
the mandrel screw and the accessory.
 Tighten using provided wrench.
If using the screw mandrel:
 Align desired accessory hole with mandrel screw head.
 Screw accessory onto mandrel by twisting clockwise until
secure.
If using the drum mandrel:
 Align appropriate sized sanding drum over mandrel and
push down to completely cover drum end of mandrel.
NOTE: If necessary, tighten the screw on the drum
mandrel head to expand the drum and securely hold the
sanding drum in place.
BALANCING ACCESSORIES
For precision work, it is important that all accessories be
properly balanced. To balance an accessory, slightly loosen
the keyless chuck and give the accessory a 1/4 in. turn. You
should be able to tell by the sound and feel if the accessory
is running in balance. Continue adjusting in this fashion until
the best balance is achieved. Replace accessories if they
become damaged or unbalanced.
INSTALLING AN ATTACHMENT HEAD TO THE
ROTARY TOOL
See Figure 5, page 15.
WARNING:
Read and understand entire Operator's Manual for each
optional attachment head used on this rotary tool and
follow all warnings and instructions. Failure to follow
all instructions could result in electric shock, fire and/
or serious personal injury.
WARNING:
This rotary tool is designed to be used only with the
attachment head models that are specified in this
Operator's Manual. Use of other attachment heads
could cause serious personal injuries or property
damage.
WARNING:
Never install, remove, or adjust any attachment head
while rotary tool is running. Failure to stop the motor
can cause serious personal injury. Never operate rotary
tool without an attachment head or the collar installed.
This rotary tool may be used with only the following HART
attachment heads:
 45 Degree Platform Guide
 90 Degree Platform Guide
 Chainsaw Sharpening Guide
 Mower Blade Sharpening Guide
 Grout Removal Guide
 Debris Shield Attachment
 Cutting Guide
To install an attachment head:
 Verify the rotary tool switch is in the OFF (O) position.
 Remove accessories and keyless chuck.
 Hold the collar firmly, then turn it counterclockwise to
loosen and remove.
 Follow the instructions in the HART attachment head
operator's manual to install the attachment head.
To remove an attachment head:
 Verify the rotary tool switch is in the OFF (O) position.
 Remove accessories and keyless chuck.
 Follow the instructions in the HART attachment head
operator's manual to remove the attachment head.
 Reinstall the collar or install another attachment head.
10 – English