Uline H-10657 Manual De Instrucciones página 2

2. Set dispenser aside and drill into wall at four marked
locations. (See Figure 3)
Figure 3
3. Install provided anchors into drywall and secure
dispenser with provided screws.
MOUNTING WITH DOUBLE-SIDED TAPE
1. Thoroughly clean wall surface using a general
purpose cleaner and a paper towel. Let dry
completely. For silicone buildup, use a pumice-type
cleaner or grout cleaner to clean the surface.
(See Figure 4)
2. Peel off paper from the
back of tape (included).
Press firmly to back of
dispenser below top screw
holes. (See Figure 5)
3. Peel off paper from the
tape on back side of
dispenser. Press dispenser
firmly to wall and hold
for at least 30 seconds to
ensure tape has completely
adhered to wall.
4. Wait 24 hours before filling
with soap to ensure that
the tape has completely
adhered to wall.
PAGE 2 OF 9
INSTALLATION CONTINUED
Figure 4
Figure 5
INSTALLING BATTERIES
Open the dispenser and locate the battery
compartment on the left side of the dispenser. Place six
AA-cell Alkaline batteries in the proper orientation and
close the cover back into place. (See Figure 6)
Figure 6
INSTALLING CARTRIDGE
1. Place cartridge on top of control box with pump
facing front and downward. (See Figure 7)
Figure 7
2. Pull pump downward and clamp into groove of
control box. Ensure nozzle of the pump is fixed into
the groove of the push rod.
3. Close dispenser cover. The LED indicator will blink
green one time, indicating dispenser is ready
to use.
4. Place hand underneath the dispenser. The LED will
blink green and dispense soap.
0724 IH-10657