Descargar Imprimir esta página

Maytag MHN30PD Instrucciones De Instalación página 8

Lavadora comercial de carga frontal
Ocultar thumbs Ver también para MHN30PD:

Publicidad

Idiomas disponibles

Idiomas disponibles

Connect
the Inlet Hoses
Insert new flat washers (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
NOTE: Use new hoses supplied with the washer. Do not reuse
old hoses.
A
B
A, Coupling
B. Washer
Connect
the inlet hoses to water faucets
r;
Make sure the washer drum is empty.
1.
1. Attach a hose to the hot water faucet. Screw on coupling
by hand until it is seated on the washer.
2. Attach a hose to the cold water faucet. Screw on coupling
2.
by hand until it is seated on the washer.
3. Using pliers, tighten the couplings with an additional
two-thirds turn.
3.
NOTE: Do not overtighten, use tape, or sealants on the valve.
Damage to the valves can result.
r
Clear water lines
[]
Run water through both faucets and inlet hoses, into a
laundry tub, drainpipe, or bucket, to get rid of particles
in the water lines that might clog the inlet valve screens.
[]
Check the temperature
of the water to make sure that the
hot water hose is connected to the hot water faucet and
that the cold water hose is connected to the cold water
faucet.
Connect
the inlet hoses to the washer
r
C
4_
C. Cold water inlet
H. Hot water inlet
Attach the hot water hose to the check valve on washer's
hot (H) water inlet valve. Screw on coupling by hand until
it is seated on the check valve.
Attach the cold water hose to the check valve on washer's
cold (C) water inlet valve. Screw on coupling by hand until
it is seated on the check valve.
Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten.
Damage to the coupling can result.
Turn on the water taps completely and check for leaks.
C
NOTE: Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Record hose installation or replacement
dates on
the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
Connect
the Drain Hose
Remove drain hose from washer drum
1. Use locking pliers, squeeze hose clamp tabs together and
insert over the end of drain hose.
8

Publicidad

loading

Este manual también es adecuado para:

Mhn30pnWhp0400vwMhn30pncgw0