Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: If any parts are missing,
damaged or broken, do not operate your
hedge trimmer until all damaged parts have been
replaced or repaired. Failure to do so could result in
serious personal injury.
A
F5
Adjusting the cutting angle (See Fig. G1 G2)
A
G1
EN
0°~10°
A
G2
Horizontally move the machine, cut using one side
of the blade, and keep the blade at an angle of 0 to
10 degrees.
10
How to Use your Hedge trimmer
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades. Always hold the trimmer
with both hands and with the blade away from you
before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch Levers before attempting to
clear jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick for
the cutting blade.
TRANSPORTATION
Transporting the trimmer
1. Switch off the trimmer and remove the battery.
2. When transporting your trimmer by hand, hold
the middle of front handle to make sure that your
machine is parallel to the ground.
3. When transporting your trimmer in a vehicle,
secure and position it to prevent movement or
damage.
MAINTENANCE
WARNING! Always remove battery before
conducting any maintenance on the
trimmer. Please wait for the machine to cool
down before performing maintenance.
Remove the battery from hedge trimmer before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your outdoor
power equipment. Always store your outdoor
power equipment in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
free of dust.
Lubricating the
Cutting Attachment
H1, H2)
(See Fig.
Publicidad
