Husqvarna PP 8 Manual Del Usuario página 35

4. In the Information center display, push shortly (A)
and (B) at the same time.
C
A
Note:
The Information center display changes
mode if (A) and (B) are pushed at the same time.
5. Push shortly (A) to see choice "2".
6. Push shortly (B) to chose "2". The symbol (C) shows
in the Information center display.
7. Push and hold (A) and (B) at the same time for 3
seconds.
8. Turn on the power pack.
9. Push and hold the on button on the power pack for
at least 3 s.
2092 - 002 - 15.01.2024
B
10. When the receiver serial number is visible in the
Information center display on the remote control,
push (B).
The pairing confirmation symbol will be visible for 2
seconds.
11. When the On/Off symbol is visible in the Information
center display, restart the remote control with the
On/Off button.
12. Restart the power pack. Refer to
pack on page 32 .
To connect the remote control to the power pack with a
CAN bus cable
1. Put one end of the CAN bus cable in the connector
(A) on the remote control.
A
To start the power
B
35