Baker GA 950 / GA 550
supervision or instruction concerning the use of the appliance in a safe way and understand the
hazards involved.
•
Any electrical or mechanical changes to this cabinet will void the warranty. Changes carried out
by non-authorized service engineers and changes other than those described in this manual will
also void the warranty. The manufacturer will not accept any responsibility for damages arising
from such changes.
CLIMATE CLASS
The cabinet is designed to run within specific ambient temperature and humidity levels. These are set
out in the climate class system. These levels are never to be exceeded. The climate class for this product can
be found on the product description label.
Climate Class
FIRST ACCEPTANCE AND CONTROLS
This cabinet was packed in protective packaging material for shipping. On delivery, please check the
cabinet for any possible transport damage and that the cabinet model is what you ordered.
All operations listed below must fully comply with all local bylaws and safety regulations. Observe all
current safety rules when operating this product.
TRANSPORTING
When lifting the product using machinery, the lifting capacity of any machinery must be verified prior to
undertaking any such procedures.
When using a fork truck to move the product, please ensure that the forks are inserted into the appropriate
openings in the pallet.
Once moving, attention must be paid to the stability of the product. If the center of gravity is not central
to the product, which will make it prone to tip over. When lowering the product with a fork truck ensure this
is done slowly and with care.
Should it become necessary to transport any upright cabinets in a horizontal position, please make
sure the cabinet has been upright for at least 2 hours before operating. It is not recommended to transport
upright cabinets in the horizontal position and any damage arising from such action is not covered by
warranty.
3
4
5
IMPORTANT
IMPORTANT
Ambient Temperatures and Humidity
+25°C with %60 RH
+30°C with %55 RH
+40°C with %40 RH
EN
3