Publicidad
Idiomas disponibles
Idiomas disponibles
3. OPERATION
Fig. 2
1.
The fan is folded, pull from the support tube to unfold it.
2. Move the fan in the direction of the arrow shown in figure 2.
3. The clamping system shall be adjusted automatically. The fan angle shall be 90°.
4. You can move the fan 180° to the left/right and up/down.
5. Press the oscillation button to activate/deactivate the oscillation function. If you press the
power button, the indicator light will show the battery level; if you press it again, the fan
will switch on. Pressing it a third time will allow you to set the speed (1-4). If you have
selected speed 4 and then press the button again, the fan will switch off.
6. The fan height can be adjusted.
7.
To fold up the fan again, raise the clamping system as shown in figure 2.
8. Then, fold down the support tube and fold the fan as shown in the figure.
9. Finally, press the fan grille with both hands. To open, press it and turn it counterclockwise.
Battery removal
To facilitate proper recycling of the product, follow these steps to remove the battery:
1.
Remove the centre piece from the base as shown in figure 3.
2. Remove the four screws that are exposed by removing the previous part.
3. Remove the base.
4. Remove the two screws holding the battery.
5. Disconnect the battery using pliers and remove the battery for proper recycling.
NOTE:
Removal of the battery should only be done for the purpose of recycling the appliance.
Replacing the remote-control battery
The remote control requires 1 x CR2025 battery.
1.
Open the battery compartment.
2. Insert the battery into the battery compartment observing the polarity.
3. Close the compartment.
4. CLEANING AND MAINTENANCE
Before cleaning the fan, make sure that it is not connected to the mains, that it is not running
and that the blades are completely stopped.
Clean the external surface of the fan with a soft cloth.
ENERGYSILENCE 800 FOLDAIR PORTABLE CONTROL
ENGLISH
35
Publicidad
