KRESS CyberLite KAC844 Manual Del Usuario página 10

Charge indicator light
Remarks
Green flash
Green on
Red on
Red flash
Power indicator light
Remarks
Green on
EN
The power indicator light
flashes green twice, then
flashes red once.
The power indicator light
flashes green three times,
and then flashes red
once.
The power indicator light
flashes green four times,
then flashes red once.
The power indicator light
flashes yellow.
BATTERY TEMPERATURE PROTECTION
This charger has a battery temperature protection
feature. When the charger detects a battery pack that
is too hot (the light will flash red), its internal fan will
rapidly cool the battery to the correct temperature.
When the charger detects a battery pack that is
too cold (the light will flash red), it automatically
activates the protection circuit, and suspends
charging until the battery pack has reached the
correct temperature. The charging process will then
automatically begin (the light will flash green). This
feature ensures maximum battery life.
IMPORTANT CHARGING NOTES:
1. When charging, it is normal that the charger and
battery pack may become warm to touch.
2. If the battery pack does not charge properly:
10
ON / flash Status
Charging
- - - - - -
Fully charged
Defective Battery
Battery
Temperature
- - - - -
Protection
Status
Charging / standby mode
Defective CyberCapsule
battery
Battery cooling fan
defective
Charger cooling fan
defective
Defective on/off switch
a. Check if the CyberCapsule battery or the charger
are damaged
b. Move the charger and battery pack to a location
where the surrounding air temperature is
0
approximately 18 C ~ 25
c. If the charging problem persists, take the tool,
battery pack and charger to an authorized service
center.
d. Under certain conditions, when the charger has
a CyberCapsule fitted, the exposed charging
contacts inside the charger can be shorted by
foreign material. Foreign materials of a conductive
nature such as metallic particles should be kept
away from charger cavities. Always remove the
CyberCapsule and batteries before attempting to
clean.
PROBLEM SOLUTION
1.I CANNOT FIT THE BATTERY INTO THE
CHARGER. WHY?
a) Check if the charger and the battery pack are
specifically designed for working together.
b) The battery can be inserted into the charger only
in one direction. Turn the battery around until it
can be inserted into the slot, the charge indicator
light should be green and flash when the battery
is charging.
2. REASONS FOR DIFFERENT CHARGING
TIMES
The charging time can be affected by many reasons
which are not defects in your product.
a) If the battery pack is only partly discharged it may
be re-charged in less than rated charging time.
b) If the battery pack and ambient temperature are
very cold / hot, it may take longer to re-charge.
Please find an appropriate environment with
proper air temperature to start charging.
c) Batteries of higher Amp Hour rating require more
charging time.
MAINTENANCE
1. Use a rain cover to cover the CyberLite charger in
rainy days.
CAUTION: Do not operate or store the
CyberLite charger in rain or wet condition
to avoid electrodes corrosion and shortening the
life. Charge the CyberPack batteries and Kress
60 V batteries after the electrodes are completely
dry in case they are wet. Replace the electrodes
if obvious verdigris appears.
2. Remove both the Kress 60V battery and the
CyberCapsule battery before carrying out any
adjustment, servicing or maintenance.
If there is dust in the drain (a), rinse it with clean
water. Wipe clean with a dry cloth. Always locate
your battery, charger and power tool in a dry
0 0 0
C (65 F ~ 77 F).