Clean A Blocked Tube / Impeller; Transportation And Storage; Move The Machine; Store The Machine - GreenWorks SBL24B00 Manual Del Operador

1. Remove the bag.
2. Turn the bag inside out.
3. Hang the bag up and clean it.
4. Hang the bag to dry.
5. Turn the bag right-side out and install it again.
12.3 CLEAN A BLOCKED TUBE /
IMPELLER
1. Wait until the machine fully stops.
2. Remove from the power source.
3. Remove the blower tube or mulcher tubes and the bag.
4. Remove the material that causes a blockage of the tube or
impeller.
5. Make sure that the impeller has no damage.
6. Turn the impeller with the hand to make sure that there is
no blockage.
7. Install the blower tube or mulcher tubes and the bag.
WARNING
Avoid the intake of large objects that could damage the
impeller.
13 TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before
tranportation and storage.
13.1

MOVE THE MACHINE

• Only hold the machine with the handgrip.
13.2

STORE THE MACHINE

• Clean the machine before storage.
• Make sure that the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
English
14

TROUBLESHOOTING

PROBLEM POSSIBLE
CAUSE
The tube has block-
ages.
The impeller has
blockages.
The bag is full.
The bag is dirty.
The machine
The bag has dam-
does not
age.
blow or
mulch.
The bag is unzip-
ped.
The battery pack is
not secure.
The battery capaci-
ty is low.
The on/off button is
in the OFF position.
The on/off button is
defective.
The tube is not in-
stalled correctly.
The machine
does not start.
The gate is not
locked.
The battery pack is
not secure.
The battery capaci-
ty is low.
15

TECHNICAL DATA

Voltage
Air volume
Air speed
Weight (without
battery pack)
Battery model
Charger model
The recommended ambient temperature range:
9
SOLUTION
Make sure that the
tube is clear.
Make sure that the im-
pller is clear.
Empty the bag.
Clean the bag.
Replace the bag.
Lock the bag.
Make sure that you
latch the battery pack
correctly.
Charge the battery
pack.
Push the on/off button.
Replace the defective
parts by an approved
service centre.
Make sure that you in-
stall the tube correctly.
Make sure that you
lock the gate.
Make sure that you
latch the battery pack
correctly.
Charge the battery
pack.
24 V
90 CFM
180 MPH ( 290 Km/h)
2.42 lbs. (1.1 kg)
29842, 29852, LB24A020, LB24A210
BAG708 and other BAG series
2903102, 29972 and other CAG series
EN