For M Ore Information - DeWalt DCS355 Manual De Instrucciones

NOTE: The fuel g auge i sonly anindication ofthecharge l eftonthe
battery p ack. Itdoes notindicate tool f unctionality andissubject to
variation based o nproduct components, temperature and end-user
application.
For m ore information regarding fuel g auge b attery packs, please call
1-800-4-DEWALT (1-800-433-9258) orvisit o urwebsite www.dewalt.
com.
Variable Speed Trigger (Fig. 16)
_ WARNING: Ensure switch is fully OFF before installing the battery
pack.
1. Install the battery pack.
2. To turn the tool ON, hold it as shown in Figure 16 and press the
variable speed trigger (A).
NOTE: The further the trigger FIG.16
switch is depressed, the faster
the tool will operate. If in doubt
about the proper speed for your
operation, test the performance
at low speed and gradually
increase until a comfortable
speed is found. A
3. To turn the tool OFF, release the variable speed switch (A).
Lock On/Off Button (Fig. 17)
Engage the lock on/off button (D), by pushing FIG. 17
it to the left or right. When the trigger (A) is
not depressed, pushing the button fully to
either side until it snaps into place will lock the
trigger and disable it from being depressed.
Placing the button in the center position D
allows the trigger to operate normally.
A
Pushing the button to the left or right with the trigger depressed
will lock the trigger in the depressed position. This allows for more
comfort and control in extended use applications. Pressing the trigger
switch again will release the lock out and the tool will turn off upon
release of the trigger.
LED Worklight (Fig. 18)
The LED worklight (B) will activate any time the trigger is depressed
and will remain on for 20 seconds after trigger is released.
FIG.18
Helpful Hints
• Always ensure the workpiece is firmly held or clamped to prevent
movement. Any movement of the material may affect the quality
of the cutting or sanding finish.
• Do not start sanding without having the sandpaper attached to
sanding platen.
Use coarse grit paper to sand rough surfaces, medium grit
for smooth surfaces and fine grit for the finishing surfaces. If
necessary, first make a test run on scrap material.
Excessive force will reduce the working efficiency and cause
motor overload. Replacing the accessory regularly will maintain
optimum working efficiency.
Do not allow the sandpaper to wear away, it will damage the
sanding pad.
13