Publicidad
Idiomas disponibles
Idiomas disponibles
MIG/MAG torch
1 - gas nozzle
2 - gas distributor
3 - contact tip
4 - tip adapter
5 - torch neck
7. Connecting the wires
CAUTION! Connecting the cables to the device must be done with the power supply disconnected
and the device turned off.
Checking the tightness of gas connections
Before first use and then at regular intervals, it is recommended to check for gas leaks. The
procedure should be carried out as follows:
1) Connect the regulator and gas line assembly and tighten all connections and clamps.
2) Slowly open the cylinder valve.
3) Set the flow rate on the controller to approximately 8-10 l/min.
4) Close the cylinder valve and watch the pressure gauge needle on the regulator. If the needle
drops towards zero, it means there is a gas leak. Occasionally, the gas leakage can be slow.
To identify it, leave the gas pressure in the regulator and the line for a long time (about 15
minutes).
5) In the event of a gas leak, check all connections and terminals for leaks. Brushing or spraying
with soapy water will cause bubbles to appear at the location of the leak.
6) Tighten clamps or couplings to eliminate gas leakage.
IMPORTANT! - It is recommended to check for gas leakage before starting the machine. It is
recommended to close the cylinder valve when the machine is not in use.
TIG welding mode
1) Connect the ground cable to the connection marked with "+" and twist the cable plug to
secure the connection.
2) Connect the welding cable to the connection marked with "-" and twist the cable plug to
secure the connection.
3) Connect the gas line from the cylinder to the TIG torch (the cylinder should be equipped with
a suitable pressure regulator).
4) Connect the TIG torch control cable to the connector on the front panel of the machine.
5) Plug the power cord into an electrical outlet and start the machine.
6) Connect the ground wire to the workpiece. Once these steps are completed, welding can
begin.
EN
Publicidad
