Publicidad
Idiomas disponibles
Idiomas disponibles
E2
2
E3
EN
LUBRICATION (SEE FIG. F)
IMPORTANT: The pole saw is not filled with
bar & chain oil. It is essential to fill with bar
& chain oil before use. Never operate the
pole saw without bar & chain oil or allow the tank
to become empty, as this will result in extensive
damage to the product.
NOTE: Chain life and cutting capacity depend
on optimum lubrication. Therefore, the chain is
automatically oiled during operation.
FILLING OIL TANK:
WARNING: Remove the battery pack before
filling the oil tank.
1. Set pole saw on any suitable surface with oil fill
cap facing upward.
2. Clean area around the oil fill cap with cloth and
unscrew the cap by turning it counter clockwise.
3. Add bar & chain oil until tank is almost completely
full.
4. Avoid dirt or debris entering oil tank, refit oil fill cap
and tighten by turning clockwise until hand tight.
It is important to use bar and chain
lubricant (not automotive oil) that is
formulated to perform over a wide temperature
10
3
1
3
1
2
range with no dilution required. This can be found
at the location where you purchased this saw or
your local hardware store. Do not use dirty, used
or otherwise contaminated oils. Damage may
occur to the bar or chain. Use of non approved bar
& chain oil will void the warranty.
Keep bar oil out of reach of children. If swallowed,
call a physician immediately. Store away from heat
or open flame.
A
F
1
OPERATION
Starting the pole saw
G
1. Push the Safety Lock Off Lever forward first, then
squeeze and hold the throttle trigger to start the
machine
NOTE: More details can be found in the power head
manual.
CUTTING
IMPORTANT: Check oil tank periodically.
Check recent replaced chain tension every
time you replace the battery pack.
(1) Installing the battery pack into the machine.
(2) Do not allow the chain to come in contact with
ground while operating as this will dull the chain.
2
Publicidad
