Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY
WARNING! Do not install the battery pack
before it has been completely assembled.
Always use gloves when handling the chain.
CHAIN AND GUIDE BAR ASSEMBLY
1. Loosen the hex nut to remove the drive cover.
Slide the chain in the slot around the guide bar.
Ensure the chain is in correct running direction.
(See Fig. A1)
2. Fit the chain onto the drive sprocket, so that
the bar locating stud on the bar pad fits into the
keyway of the opening on the guide bar.(See Fig.
A2, A3)
3. Assure all parts are seated properly. Make sure
the drive links are fully seated in the drive sprocket
(See Fig. B1), avoiding a kink as shown in Fig. B2.
If kink occurs, pick up on the chain at the guide
bar just ahead of the kink and then pull the kink
out.
NOTE: Chain should rotate freely but requires a
level of force to rotate the chain
4. Fit the drive cover and tighten the hex nut.
EN
A
A1
A
A2
8
A
A3
1
A
B1
A
B2
Kink/Plis/Torcimiento
WARNING: The chain is not yet tensioned.
Tensioning the chain applies as described
under "TENSIONING CHAIN". The chain now
needs to be inspected to make sure it is properly
tensioned.
TENSIONING CHAIN (SEE FIG. C, D)
NOTE: New saw chains will seat to the bar when
first used. Check the chain tension frequently when
first used and tighten when the chain becomes loose
around the guide bar.
Removing the battery pack before adjusting saw
chain tension.
2
Publicidad
