Publicidad
Idiomas disponibles
Idiomas disponibles
A
H4
3. Use both hands to grip the pole saw and cut
branches.
A
H5
EN
TRIMMING A TREE (PRUNING)
WARNING: Avoid kickback. Kickback can result in
severe injury or death.
See Kickback, to avoid risk of kickback.
WARNING: Do not operate pole saw while
• in a tree
• on a ladder or any other unstable surface
• in any awkward position
You may lose control of pole saw causing severe
injury.
CAUTION: Seek professional help if facing
conditions beyond your ability.
Trimming a tree is the process of cutting limbs from a
living tree. Make sure your footing is firm. Keep feet
apart. Divide your weight evenly on both feet.
Follow directions below to trim a tree.
1. Make the first cut a few inches (c) from the tree
trunk on underside of limb. Use top of guide bar
to make this cut. Cut 1/3 through diameter of limb
(See Fig. H6).
12
2
A
H6
3
2. Move a few inches (30% of c) farther up on limb.
Make second cut from above limb. Continue cut
until you cut limb off.
3. Make the third cut as close to the tree trunk as
possible fully severing the remaining stub. Use
bottom of guide bar to make this cut.
FOR BATTERY TOOLS
The recommended ambient temperature range for
discharging is -4 °F-113 °F (-20 °C-45 °C).
The recommended ambient temperature range for
the charging system during charging is 23 °F-113 °F
(-5 °C-45 °C).
TRANSPORTATION
Transporting the pole saw
1. Switch off the pole saw and remove the battery.
2. When transporting your pole saw by hand,
hold the pole of the pole saw making sure the
machine is parallel to the ground and the bar is
facing rearward.
3. When transporting your pole saw in a vehicle,
secure and position it to prevent movement or
damage.
SAW MAINTENANCE
Follow the maintenance instructions in this manual.
Proper cleaning and maintenance of saw, chain and
guide bar can reduce chances of wear. Inspect and
maintain saw after each use. This will increase the
service life of your saw. If the saw gets wet in the rain
during operation, the machine and the battery pack
should be dried before storing or charging.
MAINTENANCE AND
STORAGE OF POLE SAW
1. Remove the battery pack
2
c
1
30% of c
1/3
Publicidad
