Publicidad
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
b) Caution: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
c) NOTE: This equipment generates, uses and
can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
SYMBOLS
To reduce the risk of injury,
user must read instruction
manual
Wear eye protection
Wear ear protection
Wear dust mask
Wear hand protection
Li-Ion battery This product
has been marked with a
symbol relating to 'separate
collection' for all battery packs
and battery pack. It will then
be recycled or dismantled in
order to reduce the impact
on the environment. Battery
packs can be hazardous for
the environment and for human
health since they contain
hazardous substances.
Do not burn
Batteries may enter water
cycle if disposed improperly,
which can be hazardous for
ecosystem. Do not dispose of
waste batteries as unsorted
municipal waste.
Waste electrical products
must not be disposed of with
household waste. Please
recycle where facilities
exist. Check with your local
authorities or retailer for
recycling advice.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling the Front Handle (See Fig. A)
1. Attach the Front Handle and lower clamp on the
shaft.
2. Put the bolt through the holes.
3. Tighten the Front Handle.
A
EN
7
Publicidad
