Publicidad
Idiomas disponibles
Idiomas disponibles
Fitting the shoulder strap (Sold Seperately)
(See Fig. D2)
D2
1. Adjust the length of shoulder strap to make sure
that the carabiner is about a hand's width below
the top of your hip.
2. Connect the carabiner of the accessory shoulder
strap to the mounting point on the shaft of the
trimmer.
OPERATION:
Starting (See Fig. E)
EN
E
1. Press the On / Off Switch until the green LED is
lit. The green LED shows the power level. Press
the minus sign (-) on the speed control to select a
lower cutting speed if needed.
2. Push the Safety Lock Off Lever forward first, then
squeeze and hold the throttle trigger to start the
machine.
Selecting the speed
2 Power Levels can be selected depending on the
application. Use the +/- to control the speed, which
is as indicated by the LEDs. The higher the power
level, the faster the tool runs.
10
For Battery tools
The recommended ambient temperature range for
discharging is -4°F~113°F (-20℃~45℃).
The recommended ambient temperature range for
the charging system during charging is 23°F~113°F
(-5℃~45℃).
TRANSPORTATION
Transporting the battery
1. Ensure the battery is in a safe condition.
2. Use non-conductive packaging when
transporting the battery.
3. The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements.
Transport batteries only when the battery
housing is undamaged. Pack up the batteries in
such a manner that cannot move around in the
packaging.
MAINTENANCE
WARNING! Always remove battery before
conducting any maintenance.
Cleaning the air filter (See Fig. F1, F2)
1. Clean the area around the air filter. Use a damp
cloth or a soft brush.
2. Unscrew and remove the air filter.
3. Wash the air filter with running water to remove
the dirt.
15m (50ft)
4. Allow the air filter to dry in the air. And then install
it in the housing by thghtening the screw.
F1
Publicidad
