Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling the Front Handle (See Fig. A)
1. Attach the Front Handle and lower clamp on the
shaft.
2. Put the bolt through the holes.
3. Tighten the Front Handle.
A
EN
WARNING: Adjust the Front Handle as
desired so as to make sure your front
arm is straight during operation.
Assembling and disassembling the
attachment. (See Fig. B1, B2, B3)
1. Remove the protective cap from the end of the
attachment shaft.
2. To assemble, align the triangle icon on the button
with the arrow label on the attachment shaft.
3. Push the shafts together until you hear a "click".
The edge of the arrow label should be close to
the shaft connection housing.
4. Finish the assembly by tightening the knob
clockwise.
5. To disassemble, loosen the knob, turn counter
clockwise, then press the release button and
pull the shafts apart. Replace the protective cap
on the attachment shaft to ensure that dust and
debris do not get into the shaft.
8
B1
B2
2
B3
3
2
Installing & removing the battery pack
(See Fig. C1, C2)
3
1
1
Publicidad
