MSG Equipment MS005 Manual De Usuario página 18

English
Test bench MS005/MS005A
6.1. Installation and de-installation of the alternator
1. Use the "Release Chain" button to increase the length of the chain sufficient for securing the
alternator. A single press increases the length of the chain, and a subsequent press stops this
process.
2. Position the alternator on the working platform so that the pulley is directly above the belt.
3. Place the chain on the alternator and secure the end of the chain on the bench. Then use the
"Tighten Chain" button to tension the chain; the bench will automatically stop the chain
tensioning process.
CAUTION! Be careful not to injure your fingers.
4. Use the "Release Belt" button to loosen the belt enough to fit it onto the alternator pulley. A
single press loosens the belt, and a subsequent press stops this process.
5. Use the "Tighten Belt" button to tension the belt. The bench will automatically stop the
tensioning process.
CAUTION! Ensure that the position of the chain on the alternator is such that after tightening
the belt, the alternator is in a horizontal position (see Fig. 14). Misalignment of the alternator
leads to belt slippage on the pulley and rapid wear.
Figure 14. Installation and Fixation of the Alternator on the Bench
18