MSG Equipment MS005 Manual De Usuario página 25

Any alternator test script can be modified by the user at their discretion (see
8 – Setting the value of the alternator pulley diameter. This parameter is set for diagnosing the
alternator with rotation frequencies equal to those on the car.
During the diagnostic mode of any type of alternator, the following information may be
displayed on the screen (see Figure 23):
1 - Indicator of the control lamp operation.
2 - The "Test sense pin" button is used to check the operability of the "S" terminal. Via the "S"
(Sense) terminal, the voltage regulator reads the actual battery voltage and increases the
alternator's output voltage to compensate for charge loss.
3 - The "K15" button simulates the ignition signal supplied to the alternator voltage regulator. If
the alternator has a terminal: "A" or "IG," or "15," then it is necessary to press the "K15" button
before testing the alternator.
4 - Field for the graphic display of measured parameters.
5 - Display of the aggregate temperature from the thermal imaging camera.
6 - Control of the alternator's output voltage, if provided.
Figure 23. Alternator Test Mode Menu
English
User manual
Appendix 2).
25