Aqua Medic Ocean Clear Manual De Instrucciones página 9

1. Suspensions
2. Screws
3. Mounting bracket
4. Rubber plug
5. Float switch with bracket and mounting screw
6. Sealing cap for pump assembly
7. Take-up reel
8. Fleece holder
9. Fleece roll
10. Motor
11. Connecting rod
12. filter housing
13. Filter insert
The suspensions (1) must be mounted on the filter housing (12) according to the desired position in the filter
tank. You can attach the filter with the narrow side, in which case the suspensions are screwed directly to the
housing, or with the wide side. In this case, the two mounting brackets (3) are first screwed to the filter housing
using the countersunk screws. The suspensions are then attached to these. The filter should be immersed
approx. 9 - 10 cm into the water so that sufficient space remains up to the float switch (Fig. 2). The
edge of the filter housing should be lower than the glass edge of the filter basin so that no water can
run out of the filter housing next to the filter basin in the event of a defect. It is also important to
ensure that the fleece rolls do not rest against a glass edge (Fig. 7). Bear in mind that the roll will
be slightly thicker on the reel than when unused. Any threaded openings on the filter housing that are not
required are sealed with the rubber plugs (4) supplied.
Fig. 2: Mounting the float switch (height adjustable using a screw)
Fig. 3: Fleece mounting
9