GENERGY NATURA Serie Instrucciones De Uso página 68

6 Press the start engine switch to "START" position, release once the engine has
started according to the lower figure.
NOTE: If the engine does not start in 3 or 4 seconds, release the start engine
switch and wait a few seconds before trying again to avoid overheating the starter
motor.
7 Once started, the lamp in panel pass to green color, and then slowly turn the
choke completely to the right side (RUNNING) according figure below.
NOTE: Do not leave the choke in an intermediate position, the blend would
be too rich and the engine would not work properly.
8 After starting, allow generator runs without load for few minutes upon each initial
start-up to permit engine stabilize and increase its temperature softly, then you
can connect the loads.
65