Using The Rotary Spit - SEVERIN TO2061 Instrucciones De Uso

6.2 Using the rotary spit

When the rotary spit is used, only the upper heating elements are activated,
as fat may drip down onto the lower elements. The spit drive ensures
smooth, even turning of the food on the spit.
WARNING!
Fire hazard! Food with a high fat content may
ignite if it touches the heating elements.
– When selecting or preparing the food for
cooking, ensure that it is not too large for the
oven interior. Do not allow the food to touch the
upper or lower heating elements.
GB
– To prevent any direct contact with the heating
elements, any projecting parts (e.g. wings of a
chicken) should be held in with a tooth-pick, a
piece of string or other suitable means.
1. Ensure that the crumb tray is properly installed below the two lower
heating elements.
2. Make sure the appliance is connected to the mains.
3. Pierce the food to be cooked with the spit, making sure that it goes
through the middle. This is to ensure that the food is suffi ciently far from
the oven walls and heating elements.
4. Use the holding clamps to secure the food in the centre of the spit.
5. Insert the spit into the corresponding mountings inside the oven:
Slide the spit end-piece with the drive unit
connection into the drive opening on the
right-hand side.
36
Now place the idle end of the spit into its holding
bracket on the opposite side.
6. Close the oven door.
7. Set the temperature at the required level.
8. Turn the 5-position switch to its
spit).
9. Set the timer to the required cooking time.
Ü The upper heating elements are now switched on.
Ü The air circulation function starts automatically.
Ü The rotary spit starts turning.
Ü A quiet ticking sound can be heard from the timer.
10. While cooking:
Check the degree of browning frequently through the door window. If
satisfi ed with the result, turn the 5-position switch back to its
position.
11. Wait until the pre-programmed time has elapsed, and the acoustic signal
is heard.
Ü The heating elements switch themselves off automatically.
Ü The rotary spit stops turning.
position (upper heat with rotary
(OFF)