Installation Instructions - Cardin Elettronica SL Serie Manual Del Usuario

INSTALLATION INSTRUCTIONS

Overall dimensions and positioning
• The geared motor must be correctly positioned when it is installed: perpendicular to the ground and straight up on lat ground.
330
5
• The geared motor unit has been assembled in the fac-
tory to be itted to the LEFT SIDE of the gate (internal
view).
To install the motor to the RIGHT of the gate set dip 8 of
the dip-switch "DS1" (ig. 3) to "ON".
Anchoring the unit (ig. 6, 7)
Important! Check the exact anchoring position with respect to the alignment of the sliding gate.
• Run the piping and connection wires to the position where the motor is to be installed.
• Attach the anchor bolts to the base plate "A" allowing them to protrude by 50 mm and then tighten down using
the supplied M12 nuts.
• Prepare a cement plinth, in the position where the motor is to be installed, with a depth of 350 mm (the base
should protrude by about 25 mm to avoid damage by pools of water building up under the appliance).
• Insert the base plate making sure that:
- the electrical cables pass through the hole "B";
- the anchor bolts "C" are immersed into the cement base and the base plate is perfectly level;
- the four protruding threaded bolts are perpendicular to the base plate;
- the surface area of the base plate is clean and free of cement residue.
If the runner guide already exists the cement base should be extended to take in part of the runner guide foundation.
This will stop the two foundations from giving way separately.
- Unscrew the four M12 nuts on the four threaded bolts (previously used to block the anchor bolts) from the base
of the anchor plate. Then insert the four washers and allow them to rest on the nuts.
- Position the geared motor over the four threaded bolts and allow it to rest on the four washers.
- Fasten in to the base using the other four washers and
adjustment nuts supplied with the kit, making sure that the unit remains perfectly level and stable.
- Adjust the height if the unit using the four grub screws already positioned on the motor. This will allow you to
adjust the height and position of the motor later on.
Fitting the toothed rack
- release the geared motor (ig. 8), lay the
irst stretch of the toothed rack on the
pinion and ix it to the gate, then fasten
down all the other parts along the entire
length of the gate.
- after having fastened the toothed rack,
realign the pinion (play of 1 to 2 mm
between the toothed runner and the
pinion) using the grub screws at the
base of the geared motor. This action
will prevent the weight of the sliding
gate from damaging the unit when
working.
240
65
25
5
ON
1 2 3 4 5 6 7 8 9
2 mm
165 165
ANCHORING
THE UNIT
Plan view
ANCHORING
THE UNIT
Side view
14
perpendicular to the ground
B
C
Toothed rack
Base plate
34 69
157
104,5
7
4
6
2
M 1
A
Gate