Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• Lamps must be replaced after 12 months of operation to ensure proper
!
disinfection of your water
• Clean Quartz sleeve frequently for optimum performance
A minimum 5 m nominal pre-filter is required upstream (before) the UV system
installation point. As UV system efficiencies are dictated by penetration of the UV
light through the water column, particulate matter within the water column could
decrease the disinfection capacity, and potentially create a harmful condition
(filtration systems sold separately)
For added protection, it is recommended that a 1m absolute filter be installed
for cyst reduction prior to treatment by the UV system (filtration systems sold
separately).
Water Quality Parameters
Water quality will adversely affect the performance of your vitapur
Power
Bucket full
Add water
system, and the following levels should be utilized as a guideline for pre-treatment
indicator
indicator
requirements of the influent water supply prior to UV treatment:
Iron
Total iron count must be less than 0.3 ppm (0.3 mg/L)
Turbidity
Count must be less than 1 NTU
Tannins
Count must be less than 0.1 ppm (0.1 mg/L)
Manganese
Count must be less than 0.05 ppm (0.05mg/L)
Hardness
Count must be less than 120 ppm (7 grains per gallon)
%UVT
Must be greater than 75%
(transmittance)
If you are using untreated surface water or untreated groundwater as your source of
supply, the suitability of the water supply for potable applications must be confirmed
by the provincial / state and/or local health agency that has jurisdiction.
If the test results indicate that: (1) any of the above contaminant levels are being
exceeded, or (2) any prevailing drinking water health standards are not being met,
additional pre-treatment options must be installed that will eliminate all contaminants
posing health risks. Non-municipal water should be tested on an ongoing basis to
ensure treatment efficiency.
3
UV disinfection
®
About Your System
VPL-2
VPL-6
Rated Service
7.6LPM / 2 GPM
22.7LPM / 6 GPM
Flow
1
UV Reaction
Chamber
27.9cm x 6.3cm
48.9cm x 6.3cm
Dimensions
11"x2.5"
(L x Dia)
UV Controller
9.5 x 7.3 x 5.7cm
22.2 x 7 x 6.3cm
Dimensions
3.75" x 2.9" x 2.3"
8.75" x 2.75" x 2.5"
(L x W x D)
Power Output
115V / 50-60Hz
115V / 50-60Hz
Maximum
Operating
100 PSI
Pressure
Feed Water
4
o
C - 37
o
C
Temperature
40
F - 99
F
o
o
Range
Ambient
2
C - 40
C
o
o
Temperature
36
o
F - 104
o
F
Range
Inlet/Outlet
1/4 " FPT
Port Size
Audible/Visible
Lamp Failure
3
Device
Lamp Wattage/
14W
Current
Lamp Service
9000 Hrs.
Life
UV Reactor
Chamber
304 SS
Material
1. Flow rates stated at 95% UV Transmittance
VPL-8
VPL-12
30LPM / 8 GPM
45.4LPM / 12 GPM
48.9cm x 8.9cm
84.5cm x 8.9cm
19.25"x2.5"
19.25"x3.5"
33.25"x3.5"
22.2 x 7 x 6.3cm
22.2 x 7 x 6.3cm
8.75" x 2.75" x 2.5"
8.75" x 2.75" x 2.5"
115V / 50-60Hz
115V / 50-60Hz
100 PSI
100 PSI
100 PSI
4
o
C - 37
o
C
4
o
C - 37
o
C
4
o
C - 37
40
F - 99
F
40
F - 99
F
40
F - 99
o
o
o
o
o
2
C - 40
C
2
C - 40
C
2
C - 40
o
o
o
o
o
36
o
F - 104
o
F
36
o
F - 104
o
F
36
o
F - 104
1/2 " MPT
3/4 " MPT
3/4 " MPT
3
3
20W
25W
39W
9000 Hrs.
9000 Hrs.
9000 Hrs.
304 SS
304 SS
304 SS
o
C
F
o
C
o
o
F
3
4
Publicidad
Tabla de contenido
