26
Problem
The appliance does not turn
on.
The appliance vibrates in an
abnormal manner.
Juice does not come out of
the spout.
Excessive accumulation of
pulp in the basket.
Pulp appears excessively
wet and a low quantity of
juice is produced.
Make sure the feed chute is empty.
•
Make sure it is plugged in.
•
Make sure the safety circuit breaker is closed.
•
Make sure the locking arm is correctly hooked onto the
•
juicer cover.
If the problem occurs itself after a long period of intensive
•
use or overfilling, the motor could be in thermal protection
lock! Wait at least 20 minutes and try again. The waiting
time can be reduced by putting the appliance in a cool
place.
The vibration can be caused by:
•
Incorrect positioning of the basket. Check alignment.
•
Deterioration of the structural components of the
•
basket. Check and replace if necessary.
Accumulation of pulp in the basket. Check and empty
•
pulp if necessary.
Full container.
•
Blockage of the basket. Check and clean the basket.
•
The opening of the spout is blocked. Check and clean the
•
bowl and spout.
Use of fruit that has too much pulp or is too ripe. Check and
•
clean the bowl and basket.
Try to alternate between soft and hard fruits when using the
•
juice extractor.
Try to insert the fruit or vegetables more slowly and with
•
less force.
Make sure that the basket is always carefully cleaned with
•
a nylon brush. Put the basket under running water and use
the brush to clean the inside of the strainer (see Fig. 7),
holding the basket up against the light to make sure that
none of the perforations are blocked. Should the
perforations of the strainer remained blocked, immerse the
basket in a solution of hot water with 12% lemon juice or
vinegar to loosen the material that blocked them.
Alternatively, wash the basket in a dishwasher.
Fruit too ripe.
•
Solution
GB