Craftsman 125.46569 Manual Del Usuario página 16

OPERATION FOR CIRCULAR SAW
ADJUSTING POSITIVE 0° BEVEL STOP
WARNING:
Before performing any
adjustment, make sure the battery pack
is removed from tool. Failure to heed this
warning could result in serious personal
injury.
POSITIVE 0° BEVEL STOP
See Figure 22, page v
The saw has a positive 0° bevel stop that
has been factory adjusted to assure 0° angle
of the saw blade when making 0° (right
angle) cuts.
To check positive 0° bevel stop:
■ Remove the battery pack from the saw.
■ Place the saw in an upside down position
on a work-bench.
■ Check the squareness of the saw blade
to the base of the saw using a carpenter's
square.
To adjust positive 0° bevel stop:
■ Remove the battery pack from the saw.
■ Loosen the bevel adjustment knob.
■ Loosen the hex nut securing the adjustment
screw.
■ Turn the adjustment screw and adjust the
base until square with the saw blade.
■ Tighten the hex nut and the bevel
adjustment knob securely.
WARNING:
without having the bevel adjustment knob
securely tightened can result in serious injury.
16 ― English
Attempting a bevel cut