Troubleshooting; Esquema - Briggs & Stratton 01897-0 Manual De Instalación, Arranque Y Propietario

TROUBLESHOOTING

Problem
Engine is running, but no AC
output is available.
Engine runs good at no-load but
"bogs down" when loads are
connected.
Engine will not start; or starts and
runs rough.
Engine shuts down during
operation.
Loss of power on essential
circuits.
Briggs & Stratton Power Products Standby Generator
Installation, Start-Up and Owner's Manual
Cause
1. Circuit breaker open or defective.
2. Fault in generator.
3. Poor wiring connections or
defective transfer switch.
1. Short circuit in a connected load.
2. Generator is overloaded.
3. Shorted generator circuit.
4. Fuel Pressure is incorrect.
5. Natural gas fuel mixture is
incorrect.
1. 15 Amp fuse missing or blown.
2. Out of fuel.
3. Failed battery.
1. Out of fuel.
2. Fault indicator blinking.
1. Generator circuit breaker is open.
2. Transfer switch problems.
24
Correction
1. Reset or replace circuit breaker.
2. Contact local service facility.
3. Check and repair.
1. Disconnect shorted electrical load.
2. See "Essential Circuits".
3. Contact local service facility.
4. See "The Gaseous Fuel System".
5. See "The Gaseous Fuel System".
1. Install (new) 15 Amp fuse. See
"Know Your Control Panel".
2. Open fuel valve(s); check propane
tank.
3. Replace battery.
1. Check fuel valves, fill propane tank.
2. Count blinks and refer to "Fault
Detection System".
1. Reset circuit breaker.
2. See transfer switch manual.