Technical Data; Installation; Carrying The Machine - Rothenberger PORTACUT 185 Serie Instrucciones De Uso

The work material with chips is slippery. Do not drop it on your feet!
Upon receiving the machine, check the following:
•
Check that the machine is built conforming to the specifications stated in your order.
•
Check the overall machine for any damage or deformation caused in transit due to ac
cidents or other reasons.
•
Check that all items and accessories delivered.
In case any discrepancy is found, immediately report the fact to the shop you purchased or our
sale office.
(The contents of this manual are subject to change without prior notice)
2

Technical Data

Cutting capability:
Round.......................................
Square......................................
Angle cut ..................................
Blade speed.................................... 0,72 / 0,90 m/s (50 / 60 Hz)
Motor .............................................. Condenser motor, Voltage made to order, 420 W, 50 / 60 Hz
Protection class .............................. I
Machine dimension (L x W x H) ...... 975 x 415 x 415 ( L x B x H )
Weight ............................................ 43 kg ............................................
Standard accessories ..................... no. 56605,
3

Installation

3.1

Carrying the Machine

When lifting the machine, bend your knees to avoid a load on your waist! The
machine with chips is slippery. Do not drop the machine on your feet while
lifting!
3.2 Installation
 Put the machine in a place free from moisture.
 Put the machine on a flat surface without play or on a flat work bench.
 Secure a sufficient space around the machine. A wide space is necessary particularly when
working with long and heavy pipe.
 It is mandatory to use the Pipe Support for long and heavy pipe. Avoid excessive force ap-
plied to the machine which causes it to tilt.
 Make sure that the power source is equipped with a ground fault circuit breaker to avoid
electric shock.
 Use an earth clip when a power receptacle without a base for grounding is used (*1).
 When an extension cord is used, use the one conforming to the applicable regulations (*2).
*1 Confirmation of earth (grounding) and earth leakage circuit breaker: Before starting use of
the machine, make sure that the power supply to which this machine will be connected is fitted
with an earth leakage circuit breaker for prevention of electric shock which conforms to the oc-
cupational safety and health law, electrical equipment technical standard, etc.
PORTACUT 185 BSR
Ø 180 mm .........................
□ 150 mm ..........................
--- ......................................
Saw blade (14T.P.I Bimet-
al)
Single-ended wrench (10)
Single ended wrench (5)
ENGLISH
PORTACUT 185 BSP
Ø 180
□ 150
Ø 77mm ( 2 ½"), □ 75
49 kg
no. 56605:
Saw blade (14T.P.I Bimetal)
Single-ended wrench (10)
Single ended wrench (5)
T socket wrench (17
15