Makita 9564P Manual De Instrucciones página 7

Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees coun-
terclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
For tool with clamp lever type wheel
guard
1
2
► 1. Wheel guard 2. Bearing box 3. Screw 4. Lever
1
► 1. Screw
Pull the lever in the direction of the arrow after loosen-
ing the screw. Mount the wheel guard with the protru-
sion on the wheel guard band aligned with the notch on
the bearing box. Then rotate the wheel guard around
180°. Fasten it with the screw after pulling lever in the
direction of the arrow for the working purpose. The
setting angle of the wheel guard can be adjusted with
the lever.
To remove wheel guard, follow the installation proce-
dure in reverse.
Installing or removing depressed
center grinding wheel / multi disc
(Optional accessory)
WARNING:
• When using a depressed center wheel or multi
disc, the wheel guard must be fitted on the tool
so that the closed side of the guard always
points toward the operator.
Mount the inner flange onto the spindle. Fit the wheel/
disc on the inner flange and screw the lock nut onto the
3
spindle.
4
1
2
3
► 1. Lock nut 2. Depressed center grinding wheel/
Multi-disc 3. Inner flange
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise. To remove the
wheel, follow the installation procedure in reverse.
2
► 1. Lock nut wrench 2. Shaft lock
7 ENGLISH
1