Descargar Imprimir esta página

Craftsman 536.889252 Manual Del Usuario página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

How To Install The Speed
Control
Rod
1. Put the speed select lever to the
NEUTRAL position.
2. Attach the ball joint, located on the
bottom end of the speed control
rod,
to the shift yoke assembly,
See
Figure 9. The fasteners
are attached
to the ball joint at the factory.
3. The length ot the ball joint and speed
control
rod have been pre-adjusted
at the factory. If an adjustment is re-
quired, loosen the nut. Remove the
fasteners
to disconnect the ball joint
from the shift yoke assembly.
To
lengthen or shorten the speed con-
trol rod, turn the adapter to obtain
the correct length.
4. Make sure the speed select lever
functions correctly. Move the speed
select lever through all speeds.
Speed Select
Lever
Figure 8
Shift
Assembly
Ball Joint
How To Assemble
The Chute Deflector
1. Remove the carriage bolt. See
Figure 10.
2. Raise the chute deflector
into oper-
ating position.
3. Fasten chute deflector to flange with Operating
carriage bolt. Make sure to install
Position
with head of carriage bolt on the in-
side of the flange.
4.
5.
Fasten with washer and Iocknut.
Tighten Iocknut securely.
NOTE: Make sure all carriage bolts
in flange are tight. DO NOT OVER-
TIGHTEN.
Carriage Bolt
Chute
Deflector
Nut
Washer
Figure 10
F-041074L
10

Publicidad

loading