Craftsman 536.889252 Manual Del Usuario página 25

HOW TO REMOVE
THE SNOW HOOD
To access the spark plug, the snow
hood must be removed as follows:
1. Remove the choke control knob
(see Figure 30).
2. Remove the ON/OFF key.
3. Remove the four mounting screws.
4. Slowly remove the snow hood (see
Figure 31). Make sure that the prim-
er button hose and the ignition wire
are not disconnected.
5. To install the snow hood, first make
sure that the primer button hose
and the ignition wire are connected.
6. Mount the snow hood to the engine
and secure with the four mounting
screws (see Figure 32).
7. Align the tab on the choke control
knob with the slot in the snow hood
(see Figure 33).
8. Connect the choke control knob
with the choke shaft. Make sure the
choke control knob is properly
installed, if the choke control knob
is not installed correctly, the choke
will not operate.
Choke Control Knob
Screws
, 4s
Snow Hood
Snow Hood
/
\E
Figure 31
Figure 32
Snow Hood
Screws
F-041074L
/
ON/OFF
Key
Figure 30
25
Carburetor
Choke
Control
Knob
Figure 33