Craftsman 536.889252 Manual Del Usuario página 28

HOW TO REPLACE THE BELTS
The drive belts are of special construc-
tion and must be replaced with original
equipment replacement belts available
from your nearest Sears service center.
Some steps require the assistance of a
second person.
How To Remove the Auger Drive Belt
If the auger drive belt is damaged, the
snow thrower will not discharge snow.
Replace the damaged belt as follows.
1. Disconnect the spark plug wire.
2. Loosen the bolte on each side of
the bottom panel (see Figure 38).
3. Remove the bottom panel.
Bolt Bottom
Panel
Auger
Housing
olt
Figure 38
4. Remove screw from belt cover.
Remove the belt cover (see
Figure 36).
5. Loosen the auger belt guide. Pull
the auger belt guide away from the
auger drive pulley (see Figure 40).
6. Pull the idler pulley away from the
auger drive belt and slip the auger
drive belt off of the idler pulley.
7. Remove the auger drive belt from
the engine pulley. To remove the
auger drive belt, the engine pulley
may have to be partially rotated.
8. Remove the top four bolts that hold
together the auger housing and
the motor box. Loosen the bottom
F-041074L
28
two bolts. The auger housing and
the motor box can now be split
apart for removal of the belt (see
Figure 39).
9. Remove the old auger drive belt
from the auger drive pulley. Re-
place the auger drive belt with an
original factory replacement belt
available from an authorized service
center (see Figure 40).
10. Install the new auger drive belt
onto the auger drive pulley.
NOTE: To assemble the auger
housing to the motor box, have
someone hold the auger clutch
lever in the ENGAGED position.
This will move the idler arm and
pulley enough to allow the auger
drive pulley to move back into
position.
11. Assemble the auger housing to the
motor box with the four bolts that
were removed in step 8. Tighten the
bottom two bolts.
12. Install the auger drive belt onto the
engine pulley.
13. Slip the auger drive belt under the
idler pulley.
14. Adjust the auger drive belt. See
"How To Adjust The Auger Drive
Belt" in the Service And Adjustment
section.
15. Adjust the auger belt guide. See
"How To Adjust The Belt Guide" in
the Service And Adjustment section.
16. Install the belt cover. Tighten
ecrew (See Figure 36).
17. Check the adjustment of the cables.
See "How To Check And Adjust The
Cables" in the Service And Adjust-
ment section.
18. Install the bottom panel (see
Figure 38).
19. Tighten the bolts on each side of
the bottom panel.
20. Connect the spark plug wire.