Horn; Lighting - Vermeiren LiNX 400 Manual De Instrucciones

EN
NL
4.9.1 Limited driving speed
For your safety, the driving speed of your wheelchair will be automatically reduced when
certain body position alterations have been made. The drive of the wheelchair is then
limited to the lowest speed setting D1, or even becomes completely blocked.
Driving and speed limitations occur when:
 the lift has been adjusted to a higher position. Only speed setting D1 is available.
 the backrest inclination exceeds a certain angle
(see figure 15):
1. All functions of your wheelchair are available.
2. Only speed setting D1 is available.
3. Driving your wheelchair is no longer possible.
Raise the backrest until the block is lifted.
To lift the speed/driving limitations, lower the lift to standard (lowest) position, and adjust
your seat and backrest to upright sitting position.

Horn

4.10
Press the horn key (T) to warn bystanders, see figure 14. The horn will sound as long as the
button is pressed.

Lighting

4.11
To operate the lights:
1. Go to submenu D1, D2 or D3.
2. Tap key (U) to open the pop-up screen.
3. Tap one of the keys once to switch the light
ON, tap again to switch the light OFF:
key (V), left indicator
o
key (Y), right indicator
o
key (W), hazard warning lights
o
key (Z), front and back lights
o
When the key is activated, the light symbol is coloured, and a light symbol is shown on the
speed indication circle.
To close the pop-up screen, tap the cross key (X).
2
3
D1
16
LiNX 400
2019-01
Operating console functions
1
Backrest inclination
U
V
Y
W
Operation of the lights
X
Z