Cleaning - Ugolini NHT 1 GL Manual De Instrucciones

NHT GL
4 - Slide the outer spiral out (see figure 9) and then the inside
auger. Frequently remove the rear seal by sqeezing it to
break the suction grip (see figure 10).
5 - Remove the bowl gasket from its seat (see figure 11).
8
figure 9
figure 10
figure 11
6 - Dismantle the faucet assembly (see figure 12).
7 - Slide the drip tray out and empty it.

5. 3. 2 CLEANING

ATTENTION
Before any disassembly and/or cleaning procedure
make sure that the dispenser is disconnected from its
power source.
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
1 - Prepare at least two gallons of a mild cleaning solution of
warm (45-60 ° C / 120-140 °F) potable water and
dishwashing detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong
a solution can cause parts damage, while too mild a
solution will not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastic parts.
2 - Using a brush, suitable for the purpose, thoroughly clean
all disassembled parts in the cleaning solution.
ATTENTION
When cleaning the machine, do not allow excessive
amounts of water around the electrically operated
components of the unit. Electrical shock or damage to
the machine may result.
3 - Do not immerse the lighted top covers in liquid. Wash them
figure 12
Ugolini S.p.A.