Bracket Installation - Vermeiren V-drive Manual De Instrucciones

GB
P RTS DESCRIPTION
INST LL TION INSTRUCTIONS
1. Handset Installation
Push the controller forwards to remove it from
the clamp. Loosen both screws of the clamp
and position it around the tube of your wheel-
chair handle (You can use the circular rubber
if the wheelchair tube is too small).
Clamp
Hand
set
Lift Up
Strap
Use an Allen key to tighten the clamp around
the wheelchair handle. Slide the controller
back over the clamp.
Battery
pack
V-Drive

2. Bracket Installation

Install both brackets on the bottom horizontal
tubing of the wheelchair, using an Allen Key.
Attach the two sections of Velcro together.
Ensure that the screws are sufficiently tight and
do not rotate on the tubing.
Controller