EdilKamin INPELLET 49 Instalación Uso Y Mantenimiento página 38

POSSIBLE TROUBLESHOOTING
8) Signalling: Check button
Problem: signals an anomaly on the emergency button
Actions: • check maintenance status of the button and its board connection cable.
9) Signalling: "Battery check"
Problem: The insert does not stop but the error appears on the display.
Actions: • The buffer battery of the control board needs changing (DEALER). Remember that it is a component
subject to wear.
10) Problem: Remote control not working
Actions: • closer to the receiver of the insert
• check the battery and if necessary, replace it.
11) Problem: Outlet air not hot
Actions: • clean heat exchanger from inside the fi rebox.
NOTA 1
All signals/warnings remain shown until you intervene on the remote control, by pressing the button
Do not use the insert before having eliminated the problem.
It is important to tell the Dealer exactly what the panel signals.
NOTA 2
After 1000 kg of pellets consumed, the display fl ashes the wording 'Mainten.'.
The insert works, but you must call the Dealer out to perform extraordinary maintenance.
NOTA 3
If due to the quality of pellets or particularly critical installation, the insert becomes clogged earlier, the message "CALL
SERVICE" will appear. Proceed as per "Mainten." instructions.
N.B.:
The combustion chambers and smoke ducts connected to the solid fuel appliances must be cleaned once a year (check if your
country has specifi c legislation covering this).
Failure to regularly check and clean increases the likelihood of a fi re in the chimney pot.
In that case, proceed as follows:
do not shutdown with water;
empty the pellet tank;
contact specialised staff before restarting the machine.
- 38
-
.