SEA 23001210/15 Manual De Instrucciones página 3

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
TR1
TR2. Trimmer: Motor torque setting
Turn the Trimmer completely into clockwise direction for maximum torque.
TR3. Trimmer: Pedestrian opening setting
For pedestrian opening time setting from 0 to 15s.
Tr4 Trimmer: Braking on limit switch setting
For braking force on limit switch setting.
Note: It is very important to set the brake in function of the set torque. If the value of the torque decreases, it is
necessary to increase the braking value turning the trimmer clockwise.
1 ON
Open-Stop-Close-Open logic
Automatic/semi-automatic logic
1 OFF
(depends on the trimmer setting)
ON
2
Reclosure with activated photocell
OFF
2
Reclosure with disactivated photocell
WORKING TIME PROGRAMMING
1) Put the gate on halfway.
2) Keep pressed P1 for three seconds, until the LEDs 1 and 2 blink alternately, at this point press P2 and release the
two buttons.
3) Make sure that the automation starts closing. If the limit switch of closing has been read, the automation does not
start automatically in opening again, reverse the limit switches and repeat the selflearning from step 1.
4) If the automation starts properly, it will execute automatically a CLOSE-OPEN-CLOSE cycle and will end the
learning of the times.
Cod. 67410712
®
TRIMMER SETTINGS
TR2
-
+
TR3
NOTICE:
TURN THE
TRIMMER
CLOCKWISE
TR4
TIMES / VALUES
INCREASE
DIP SWITCHES SETTING
Selflearning of the working times with limit switch
English
TR1. Trimmer: Automatic reclosing time (0:4 min.)
It allows to set the pausing time from 0 to 4 min. With trimmer
on 0 the logic will be semi-automatic, turning the trimmer
clockwise the logic becomes automatic.
See Step-by-step logic
See automatic and semi-automatic logic
If the DIP SW 2 is on, the gate will close automatically 2
seconds after having passed the photocell
Rev. 00 - 03/2012
.
3