Resistance Measurements; Continuitycheck; Diodetest - koban KMD-16 Manual Del Usuario

KMD-16
TRMS Multimeter

5.6 Resistance measurements

WARNING:To avoid electric shock, disconnect power to the unit under test and discharge all capacitors before taking any
resistance measurements. Remove the batteries and unplug the line cords.
1. Set the function switch to the
Insert the red test lead plug into the positive Ω jack.
Press the MODE button to indicate "Ω" on the display.
2.
3. Touch the test probe tips across the circuit or part under test. It is best to disconnect one side of the part under test so the
rest of the circuit will not interfere with the resistance reading.
4. Read the resistance in the display.

5.7 Continuitycheck

WARNING:To avoid electric shock, never measure continuity on circuits or wiresthat have voltage on them.
1. Set the function switch to the
Insert the black lead plug into the negative COM jack. Insert the red test lead plug into the positive Ω jack.
2.
Press the MODE button to indicate"
3.
4. Touch the test probe tips to the circuit or wire you wish to check.
If the resistance is less than approximately 50Ω, the audible signal will sound. If the circuit is open, the display will
5.
indicate "OL ".

5.8 Diodetest

98
position. Insert the black test lead plug into the negative COM jack.
position.
"and "Ω" on the display
www.grupotemper.com