Leveling The Range - Avanti ER2001G Manual De Instrucciones

Cocina electrica
Ocultar thumbs Ver también para ER2001G:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3-Wire Power Cord Installation
Remove the Terminal Block Access Plate on the back
of range by removing the 2 fixing screws.
Assemble the strain relief in the hole on bracket.
Insert the power cord through the strain relief and
Cut Ground Strap
tighten.
Terminal Block
Allow enough slack to easily attach the cord terminals
to the terminal block.
Remove the 3 wire terminal nuts and washers from
the terminal block.
Grounding Wire
Plug the terminal holes of power cord. The neutral or
ground wire of the power cord must be connected to
the neutral terminal located in the center of terminal
block. The power leads must be connected to the
outside terminals.
Plug washers and tighten nuts securely.
Assemble the Terminal Block Access Plate.
4-Wire Power Cord Installation
Remove the Terminal Block Access Plate on the back
of range by removing the 2 fixing screws.
Assemble the strain relief in the hole on bracket.
Insert the power cord through the strain relief and
tighten.
Allow enough slack to easily attach the cord terminals
to the terminal block.
Remove the 3 wire terminal nuts and washers from
the terminal block.
Remove the ground strap from the frame of range and
terminal by removing its screw and cutting is as
shown.
Plug the terminal holes of power cord. The neutral wire of the power cord must be connected to
the neutral terminal located in the center of terminal block. The ground wire of the power supply
cord must be attached to the frame of range by using the green colored grounding screw. The
power leads must be connected to the outside terminals.
Plug washers and tighten nuts securely.
Assemble the Terminal Block Access Plate.

LEVELING THE RANGE

The range must be level to obtain proper operating. The four screws
type leveling legs located on the corners at the bottom of range should
be adjusted by turning them clockwise to make the range higher or
counter-clockwise to lower the range until the range is level. Use a
level on surface units to check the leveling of the range.
Neutral Wire
Power Wires
Power Cord
Bracket
Grounding Screw
Terminal Block
Access Plate
Cut Ground Strap
Terminal Block
Neutral Wire
Power Wires
Power Cord
Bracket
Cut Ground Strap
Terminal Block
Neutral Wire
Grounding Wire
Power Wires
Power Cord
14
Screws
Grounding Screw
Bracket

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Er2002cssEr2401gEr2402css

Tabla de contenido