Lift-Up Cooktop; Removable Storage Drawer; Replacing The Oven Light - Avanti ER2001G Manual De Instrucciones

•
After the unit has been removed, the reflector bowl can be lifted out of the
•
Clean the burners and reflector bowls with mild detergent and warm water. Wring excess water
out of the sponge or cloth when cleaning them.
•
Replace the burners and reflector bowls as follows:
•
Line up the opening of the reflector bowls with the burners receptacle, hold the surface unit as
level as possible with th
units' terminal into the receptacle.
•
When the terminal is pu
the surface unit opposite the receptacl
NOTE: Do not imme rse burners in water
liquids.

LIFT-UP COOKTOP

You can access the area beneath of the cooktop fo
cleaning purposes by lifting up the cooktop. In orde
do so:
•
Unplug the power cord from the wall
•
Hold the cooktop from
of cooktop and pull it up.
•
After lifting up the cooktop high eno
support rod into place
•
Leave the cooktop on the tip of supp
•
Wipe with warm soapy water. Use a
wool pad on heavily soile
•
To lower the cooktop, lift the cooktop
the front edge. Replac
previous position. Lower the cooktop i
During replacement of the cooktop, be
front edge of the cooktop covers the u
control panel.
NOTE: Do not drop the cooktop. Person
damage to the cooktop frame could result.

REMOVABLE STORAGE DRAWER

F
or cleaning, you can remove the drawer by pulling it out until the stop
p oint and lifting it up.
N ever store any flammable material in the drawer.

REPLACING THE OVEN LIGHT

Before any maintenance is started involving electrical parts of the appliance, it must be disconnected
from the power supply.
•
Let the oven cavity and broil burner cool down.
•
Switch off the electric supply.
•
Remove the protective cover.
•
Unscrew and replace the bulb with a new one suitable for using in high temperatures (300°C ~
570°C / 572ºF – 1058ºF) having the same specifications: 250V 60Hz, 15W, E14.
•
Replace the protective cover.
NOTE: Oven bulb replacement is not covered by your guarantee.
e terminal just positioned into the rec
shed into the receptacles as far a
e.
or an othe
the front left and right corners
ugh, set the
as shown.
ort rod.
soapy steel-
d areas.
holding from
e the suppo rt rod to its
n its place.
sure that the
pper edge of
al injury or
eptacle, then push the surface
s it will go, push dow
y r
r
r to
Support Rod
23
mounting.
n the edge of