Memory Function - Danby DMW11B1BBSDB Manual Del Propietário

OPERATING INSTRUCTIONS
EXPRESS COOK FUNCTION
When the appliance is not in operation, press the
number pad from 1 to 6 and the appliance will run
between 1 and 6 minutes at 100% cooking power.
WEIGHT DEFROST
The defrosting time and power level are adjusted
automatically once the weight is entered.
1. Press the Weight Defrost button. The display will
show "dEF1".
2. Use the number pad to enter the weight of the
food that will be defrosted. Weight must be in
pounds and ounces. Maximum weight is 6 lbs.
4 oz.
3. Press the Start/+30SEC button to confi rm.
During operation the appliance will pause and beep
to indicate that the food should be turned over or
stirred. Press the Start/+30SEC button to resume
operation.
TIME DEFROST
1. Press the Time Defrost button. The display will
show "dEF2".
2. Use the number pad to enter the desired
defrosting time. The maximum time is 99 minutes
and 99 seconds.
3. The default power level is 3, 30%. The display
will show "PL3".
4. To change the power level, press the Power
button and then press the number pad for the
desired power level.
5. Press the Start/+30SEC button to confi rm.
ADD 30 SECONDS FUNCTION
When the appliance is not in operation, pressing
the +30SEC button will run the appliance for 30
seconds at 100% power level. This button can be
pressed multiple times, each press will add a further
30 seconds to the cooking time.

MEMORY FUNCTION

The memory function allows the programming of
cooking times and powers that can be recalled and
used again and again with minimal input. Three
memory programs can be set at one time, they are
labeled 1, 2 and 3.
To set Memory 1:
1. Press the 0/Memory button once. The number 1
will display.
2. Press the Time Cook button and then use the
number pad to enter the desired cook time.
3. Press the Power button once. The power level
will default to 100%. "PL10" will display. To
change the power level, use the number pad to
enter the desired power level.
4. Press the Start/+30SEC button to save the
setting.
5. To use the setting in future, press the 0/
Memory button once and when the number 1
is displayed, press the Start/+30SEC button to
begin operation.
To set Memory 2 or 3, press the Memory button two
or three times until the number 2 or 3 are displayed
and then follow the steps above.
Note: If the power is lost or the appliance is
unplugged, the memory settings will need to be
reprogrammed.
SETTING THE CHILD LOCK
To set the child lock, while the unit is in standby
mode, press and hold the Stop/Clear button for 3
seconds. The appliance will beep to indicate that the
child lock is activated. While locked, the appliance
cannot be used.
To cancel the child lock, press and hold the Stop/
Clear button for 3 seconds. The appliance will beep
to indicate that the child lock has been deactivated.
10