Starting And Stopping The Machine - stayer SC250W Manual De Instrucciones

To avoid deformations of the workpieces during
fixing thereof, the use of wooden profiles being
easily applicable to the movable jaws of the clamps
is advised. Clamps can be easily extracted and
leave the working surface totally clear.
For cutting long workpieces under safe conditions it
is essential to hold them with additional supports.
11.Limits regarding the workpiece
size
Limits for all models as included in the
present manual
SC250W:
Limit of the workpiece
Kind of cut
90º 140x75
45º 90x75
45º Inclined 130 x 52
45º-45º 70 x 50
Composed
Upper table 0-40
SC2500W:
Kind of cut Limit of the workpiece
90º 135x75 / 60x95
45º right 90x75 / 35x100
45º left 90x75 / 35x100
45º Inclined 135x45 / 55x65
45º-45º 43x65 / 85x55
Composed
0º linear 60x95
45º linear 55x65
Tube ø 75
Upper table 0-40
SC2600W:
Kind of cut
Límit of the workpiece
90º 55x125
45º Inclined 45x125
45º-45º 45x80
Composed
45º linear 55x80
Upper table 0-42
12.General instructions for use
Warning!
1. Do NOT use the machine if it is in a bad condition
or lacks parts including the prescribed upper
guards (the illustrations of the present manual
may be used as an orientative guide). Unplug it,
remove it from the working area and immediately
send it to an authorized technical service.
ENGLISH
32
size in mm
size in mm
size in mm
32
2.Know and comply with all safety measures before
you start the machine.
3. Obligatory used of aspiration particle system
when cutting the wood.

Starting and stopping the machine

IMAGES
A B
Information
1.The machine is provided with a locking button 3
for starting allowing the motor to run without
needing to push switch 2 permanently.
2.The equipment is provided with a safety module
protecting it against unexpected starts. If, whilst
the machine is running, the supply of electrical
power should cease, the machine will not start
after reestablishment thereof. To release the
protection push the starting button 2 twice.
3.All models are single speed.
Warnings!
1.Avoid locking whenever possible (button 3).
2.Never leave running machine unattended.
3.Never start the machine with locked disk and,
before starting a cut, always wait until the cutting
disk has reached its maximum speed.
4.Before stopping the machine the disk must be
clear and be rotating freely.
Starting with the manual switch
1.Push switch 2 to actuate the motor.
Stopping the machine when actuated with the
manual switch
1. Stop pushing switch 2.
Starting with locking
1.Push switch 2.
2.Push locking button 3 whilst keeping switch 2
pushed.
3.Release switch 2.
N