Cleaning And Maintenance - HSM Powerline 450.2 Instrucciones De Servicio

6 Troubleshooting
Pa per jam
You have fed in too much paper.
 Paper shredder jammed.
 Red LED in the key pad fl ashes.
 Paper shredder reverses automatically.
Notice! Do not press dashed arrow button and
green arrow button alternately forwards
and backwards.
Cutting unit can be damaged.
CAUTION!
Injuries by cutting rollers are possible even
when the paper shredder is idle. Keep
hands away from the cutting system!
• Open the fl ap and clear the paper jam.
If material is not completely pushed
out, then
• Close the fl ap again.
• Press dashed arrow button.
 Paper is pushed out.
• Pull paper out.
• Separate paper stack and feed paper
again.
• The shredding process is started again
with the green arrow button or by the
light barrier (paper feed).
Electric motor overheated
 Red LED on membrane keyboard lights.
 Paper shredder switches off automati-
cally.
• Allow paper shredder to cool down for
approx. 15 to 20 min.
Front door or fl ap opened
 Red LED on membrane keyboard lights.
 Paper shredder stops automatically.
• Close door and fl ap.
Note If the door is opened when the cutting
device is running, the document shredder
must be started again using the green but-
ton after the door of the document shred-
der has been closed.
12
Bag for shredded material full
 Red LED on membrane keyboard lights.
 Paper shredder stops automatically.
Note Reversing the cutting device ("Reverse"
button) is also possible even when the
shredded material container is full.
• Insert new bag.
Notice! Empty the shredded material container af-
ter the paper shredder has been switched
off, because otherwise malfunctions of
the cutting system could occur when the
rocker switch is pressed several times in
succession.

7 Cleaning and maintenance

Switch off the shredder and pull out the mains plug.
When cleaning only use a soft cloth and a mild
soap-water solution. However, no water must enter
the equipment.
• Run cutting system forwards and back-
wards several times without feeding
paper.
 Paper dust and particles are shaken off.
8 Disposal / Recycling
Dispose of the machine in an environ-
mentally sound way at the end of its
service life. Observe the current regula-
tions when doing this. As legislation is
subject to ongoing changes, we request
that you contact your local authorities at
the appropriate time. As the manufac-
turer, HSM would be glad to advise you on the
disposal of your old machine.
Powerline 450.2
english english
Oil the cutting unit when
cutting performance decreas-
es or the device becomes
noisy, or every time you empty
the waste container:
Spray special cutting block oil
through paper feed opening
across the whole width of the
cutting system blades.
05/2016