Using The Pap Setting - Sony GXD-L65H1 Manual De Instrucciones

Using the PAP Setting

You can show two pictures from different signal sources, such as a PC and a video, side by side.
You can also swap the active pictures, or change the balance of picture sizes.
You can also access the "PAP Setting" in the "Screen" settings. See page 27.
For P&P
Press G button.
Press g button.
For PinP
Press G/g button.
Press
Tips
• The cursor indicating the active picture will disappear after 5 seconds.
• The picture can be adjusted to 15 sizes. (For P&P)
16
GB
The width of A and B is
the same.
The height will be set to
match each picture's
aspect ratio.
The width of A is larger
than that of B.
If A's aspect ratio is
4:3, its height will be
equal to the panel size.
B on the right side
becomes the active
picture.
Press g button.
The inset picture (B) is
shown within the main
picture (A).
The inset picture (B)
becomes the active
picture.
button.
The position of the
inset picture (B) will
change.
Press F button.
Cursor showing active picture
The width of A and B is the
same.
The height will be set to
match each picture's
aspect ratio.
Press g button.
The width of B is larger
than that of A.
If B's aspect ratio is 4:3,
its height will be equal to
the panel size.
Press f button.
B on the right side
becomes small while
remaining the active
picture.
The size of the inset picture
(B) will become large.
Press f button.
The size of the inset picture
(B) will become small.